Reloading smb.conf and applying changes

classic Classic list List threaded Threaded
2 messages Options
Reply | Threaded
Open this post in threaded view
|

Reloading smb.conf and applying changes

Samba - General mailing list
Hello,

     I'm attempting to make changes to the parameter "log level =" and
reload my changes using "smbcontrol all reload-config" but the changes
are not being invoked. I need to stop/start samba completely for my
changes to take effect. I'm specifically trying to alter debug class
levels. Is there a command I should use or must I completely stop samba
to make these changes?  Thanks.

--
--
James


--
To unsubscribe from this list go to the following URL and read the
instructions:  https://lists.samba.org/mailman/options/samba
Reply | Threaded
Open this post in threaded view
|

Re: Reloading smb.conf and applying changes

Samba - General mailing list
On 12/22/2017 11:09 AM, lingpanda101 wrote:
> Hello,
>
>     I'm attempting to make changes to the parameter "log level =" and
> reload my changes using "smbcontrol all reload-config" but the changes
> are not being invoked. I need to stop/start samba completely for my
> changes to take effect. I'm specifically trying to alter debug class
> levels. Is there a command I should use or must I completely stop
> samba to make these changes?  Thanks.
>
Digging a bit deeper I see it's one class that doesn't seem to apply
changes for me. The dns class. Making a change to "auth_audit" or "log
level" takes effect as soon as I increment the level without reloading.

--
--
James


--
To unsubscribe from this list go to the following URL and read the
instructions:  https://lists.samba.org/mailman/options/samba